Batelithium
12.8V 100Ah LiFePO4 battery guide for Canada
A 12.8V 100Ah LiFePO4 battery stores 1.28kWh of nominal energy. It is suited to small solar systems, RVs, marine house loads, CCTV, DC backup and portable power when the load current stays within the selected BMS limit.
Use a LiFePO4-compatible charger and confirm its voltage and current settings before connection. Isolate the load, verify polarity, tighten protected terminals to the specified torque and fit a correctly rated fuse or DC breaker close to the positive terminal. Never charge below the battery model's permitted temperature range.
Before installation, add the continuous and surge current of every load, check cable size and ventilation, and secure the battery against movement. Series or parallel connection is permitted only when the specific model, BMS and wiring plan support it; packs should be the same model, age and state of charge.
LiFePO4 cells can deliver long service life when depth of discharge, temperature and charge settings remain within specification. Inspect cables and terminals periodically, keep the enclosure dry and clean, and recharge stored batteries on the schedule in the product manual.
Stop using the battery if the case swells, cracks, overheats, smells unusual or shows damaged terminals. Do not short circuit, crush, puncture, open, immerse or expose the pack to fire. Product configuration and local transport requirements must be confirmed against the final datasheet and shipping documents.
For this 12.8V 100Ah battery, distinguish nominal energy from available load power. A runtime estimate needs the usable discharge allowance, average load and conversion losses. Check the selected charger settings and the battery current limits before installation; a larger inverter does not increase the current the battery may safely deliver. The related product page retains the full technical table for that comparison.